CLICK ON USED GEAR TO GO BACK

Item U226A

NAGRA ATN 3 POWER SUPPLY, CHARGER UNIT IS WORKING AND THERE ARE RUBBER END COVERS AND IT HAS A PILOT LEAD


THIS ATN 3 IS IN GOOD CONDITION AND THE POWER SUPPLY AND CHARGER ARE IN PERFECT WORKING ORDER,

POWER SUPPLY FOR NAGRA MONO, STEREO OR TIME CODE RECORDER,

NAGRA MODEL : - IV.L, 4L , 4.2, E, D, IV.S / 4S, 4S T/C, BUT MUST NOT BE USED ON A NAGRA 111

THESE ATN 3 NAGRA POWER SUPPLY WILL WORK IN ALL COUNTRIES AND I WILL SUPPLY THE CORRECT MAINS LEAD FOR YOUR COUNTRY

THIS POWER SUPPLY WORKS FROM 110 TO 250 VOLT AC 50Hz OR 60Hz MAINS SUPPLY, WITH A -35 VOLTS DC OUTPUT WITH A 6 PIN TUCHEL PLUG TO FIT THE NAGRA, THIS WILL GIVE YOU A MUCH FASTER FORWORD AND REWIND SPEED

This mains power supply has a built in charger with on/off switch

I have clean and serviced this unit and it's with the original pilot lead

ABOVE IN THE BASE OF THE ATN-3 IS THE VOLTAGE ADJUSTMENT, THAT IS SET AT 240 VOLTS FOR THE UK, THE MAINS SUPPLY MUST BE UNPLUGED BEFORE CHANGING THIS VOLTAGE SETTING

PLEASE NOTE: -ALL NAGRA’S ARE (+) POSITIVE CASE /SCREEN ON THE DC SIDE

WITH ALL NAGRA'S IT IS NOT A PROBLEM WHEN CONNECTING SCREENED AUDIO SIGNALS BETWEEN THE NAGRA (+ POSITIVE CASE/SCREEN) AND NEW EQUIPMENT (- NEGATIVE CASE/SCREEN). YOU CAN CONNECT THE AUDIO INPUT & OUTPUT CASE/SCREEN TOGETHER, BUT BOTH UNITS MUST BE POWERED FROM THEIR OWN BATTERIES OR OWN POWER SUPPLY.

IF YOU ARE CONNECTING YOUR NAGRA TO VALVE EQUIPMENT YOU WILL NEED TO USE THE ATN TRANSFORMER TYPE POWER SUPPLY, AS THE SMPS THAT IS LISTED ON THIS WEBSITE COULD NEED THE EARTH REMOVING FROM THE MAINS PLUG, AS YOU CAN GET PROBLEMS FROM A LOOP EARTH.


To buy this item please telephone:

MIKE HARRIS 01932 241948 and quote the reference number. For overseas callers

please dial +44 1932 241948