NAGRA I-S MONO CCIR FULL TRACK ANALOGUE REEL TO REEL TAPE RECORDER
THIS NAGRA IS IN GOOD CONDITION AND PERFECT WORKING ORDER.
IT HAS BEEN SERVICED BY ``MIKE HARRIS SOUND SERVICES``AND HAS A 3 MONTH GUARANTEE
To buy this item please telephone, 01932 241948 or email : Mike Harris, firstname.lastname@example.org
This Nagra IS Recorder is smaller than a Nagra 4.2 and a masterpiece of engineering that runs on 3 stepper motors
This recorder has push button fast foreword and rewind, push
ones to start, push again to stop, a playback button and press the red and line
buttons together to record, all driven by 3 stepper motors. Even
the lid cache is a work of art
A nice clean undamaged Tape Recorder in perfect working order,
ABOVE LEFT, the ALC control is not fitted. But I have an IS in stock with the ALC fitted
You can read the battery level when you push the rewind button when in play or record.
ABOVE LEFT, the ALC control is fitted in the new stock IS
ABOVE RIGHT, L.F.A FILTER switch( low frequency attenuator) and TAPE DIRECT switch, 2 control is the microphone 2 line & playback control, the 4 mm sockets are the 4.4 volt transformer LINE OUTPUT
ABOVE LEFT, the REF .GEN, put a -8 dB tone in the tape when in record, when the slider under the buttons is pushed to the right, it stops the record button being pushed accidentally when playing tapes.
ABOVE RIGHT, top the mono headphones socket, headphone level control and pilot socket, but there is no pilot link plug as this recorder is a non-pilot version
Please Note, This Nagra has a battery box fitted and the handle fixing screw will be sold with the Nagra. The IS will be supplied with the roll of tape that was used to line up this recorder, that now has some test tones and music on for you to test the IS and a take up spool. x a copy of the instruction manual. But Batteries will not be included
ABOVE LEFT, 2 Handle fixing screw sockets, then the Headphone socket and the pilot sync plug and socket, the 2 x 4 mm line in banana plugs and the 7 pin Tuchel socket that has line in, pilot and speed control inputs, the clever thumb lever ,when rotated to the right lowers the battery fixing and the battery box or power supply lifts out. To open this recorder, first open the Perspex lid, unscrew the to larger screws (2-3 terns only), that is under the 2 screw on the lilt bar, hold the headphone socket housing and lift the lift bar.
LEFT ABOVE, the other thumb lever you rotate to the left, and on the back of the 2 x XLR Microphone inputs is the XLR lock release lever
ABOVE, Information on the push button controls and switches that's on top plate of recorder
ABOVE LEFT, a sprung pin on the right hand hinge will slide out with you finger nail to remove the Perspex lid, this recorder has 3 types on power units that are available to clips on to the recorder, a Battery box that uses 10 x C type or MN1400 batteries, or IACC Rechargeable battery unit, or a Nagra mains power unit,
ABOVE RIGHT, The new stock has no PHANTOM microphone input it just has DYNAMIC or "T" powered on both microphone inputs
ABOVE RIGHT, Record, Pilot & playback heads are as new, as is the pinch roller.
ABOVE RIGHT, is the speed change on this 2 speed recorder. BRAKES use when splicing to tape.
ABOVE RIGHT, switches for 50 or 60 Hz pilot and switches for type of meter you prefer from, modulo meter, super VU-meter or peak VU-meter
To buy this item please telephone: Mike Harris 01932 241 948, or Email, email@example.com