Item U197

NAGRA I-S MONO CCIR FULL TRACK ANALOGUE REEL TO REEL TAPE RECORDER

THIS NAGRA IS IN GOOD CONDITION AND PERFECT WORKING ORDER.
IT HAS BEEN SERVICED BY
``MIKE HARRIS SOUND SERVICES``AND HAS A 3 MONTH GUARANTEE

To buy this item please telephone, 01932 241948 or email : Mike Harris, mike.sound@btinternet.com

This Nagra IS Recorder is smaller than a Nagra 4.2 and a masterpiece of engineering that runs on 3 stepper motors

This recorder has new rechargeable batteries fitted in the battery box and a mains charger, and comes with test tape and take up spool, and copy of instruction manual.

This recorder has push button fast foreword and rewind, push ones to start, push again to stop, a playback button and press the red and line buttons together to record, all driven by 3 stepper motors. Even the lid cache is a work of art

A nice cleaned undamaged Tape Recorder in perfect working order,

ABOVE LEFT, this one is with A.L.C, Automatic level control or meter level, and you can read the battery level when you push the rewind button when in play or record.

ABOVE RIGHT, L.F.A FILTER switch( low frequency attenuator) and TAPE DIRECT switch, 2 control is the microphone 2 line & playback control, the control between the 4 mm LINE INPUT sockets is the Headphone level, This Mod is not fitted on the recorder I am selling now.

ABOVE LEFT, the REF .GEN, put a -8 dB tone in the tape when in record, when the slider under the buttons is pushed to the right, it stops the record button being pushed accidentally when playing tapes.

ABOVE RIGHT, the recorder I have now has no speed change and is 7.5 ips. BRAKES use when splicing to tape.

ABOVE LEFT, 2 Handle fixing screw sockets, then the Headphone socket that will take a mono or stereo headphones and the pilot sync plug and socket, the 2 x 4 mm line in banana plugs and the 7 pin Tuchel socket that has line in, pilot and speed control inputs, the clever thumb lever ,when rotated to the right lowers the battery fixing and the battery box or power supply lifts out. To open this recorder, first open the Perspex lid, unscrew the to larger screws (2-3 terns only), that is under the 2 screw on the lilt bar, hold the headphone socket housing and lift the lift bar.

LEFT ABOVE, the other thumb lever you rotate to the left, and on the back of the 2 x XLR Microphone inputs is the XLR lock release lever

ABOVE LEFT, is the microphone input switching, this recorder has Dynamic or 48 volt phantom T powered Capacitor microphone inputs

ABOVE, Information on the push button controls and switches that's on top plate of recorder

ABOVE LEFT, The battery box had corroded batteries inside, that has been cleaned out, but as the connections where not 100% I have soldered rechargeable batteries into the box and supplied a charger, the box also has an on off switch. This battery box is included with the recorder.

A sprung pin on the right hand hinge will slide out with you finger nail to remove the Perspex lid, this recorder has 3 types on power units that are available to clips on to the recorder, If you don't use the above unit, you can use a Battery box that uses 10 x C type or MN1400 batteries, or IACC Rechargeable battery unit, or a Nagra mains power unit, only one of these battery boxes can be supplied if you take the rechargeable IACC unit.

ABOVE RIGHT, Record, Pilot & playback heads are as new, as is the pinch roller.

ABOVE RIGHT, switches for 50 or 60 Hz pilot and switches for type of meter you prefer from, modulo meter, super VU-meter or peak VU-meter

To buy this item please telephone: Mike Harris 01932 241 948, or Email, mike.sound@btinternet.com