CLICK ON USED GEAR TO GO BACK

Item U144

If you don't, have switchable microphone inputs see below


If you have the switchable microphone inputs this is not for you, if you don't, to change the mike or line pre-amps take out the two screws under the Nagra as above and pull the plug in amps out, you can use 6 types 5 microphone and 1 line input

above is a QPM-6 LINE INPUT PREAMP, above a QPSI MICROPHONE PREAMP, above a QPM 3-5 MICROPHONE PREAMPLIFIER,

there is allso the QPM3-4 and a QPAI also a QPSE xoyo

QPM-6 ASYMMETRICAL LINE INPUT, makes the 3 pin XLR a line input,

QPSE MICROPHONE PREAMPLIFIER 200 or 50 Ohm Dynamic microphone input, or any microphone with internal battery.

QPSI MICROPHONE PREAMPLIFIER as above

QPM 3-5 MICROPHONE PREAMPLIFIER, makes the 3 pin XLR a microphone input, that powers the 12 volt "T" powered microphones like the Sennheiser MKH 405, 415, 805, & 815 T these microphones are the same as the MKH 435, 416, 816 P48 phantom powered microphones but work from 12 volt "T" and are much cheaper to perches.

QPM 3-4 as above but older type

Other microphone inputs used with the Nagra 4 / IV-

SENNHEISER KAT 15-2 see item UA210 plugs into the line input and uses the line level control

AKB-11 12 VOLT see item UA100 Plugs into a Dynamic input and powers the 12 volt "T" microphones

Dual 12- 48 volt Phantom microphone power supply, see item UA48 plugs into dynamic input


To buy this item please telephone: MIKE 01932 241948 OR Email mike.sound@btinternet.com