CANFORD POWERED DIECAST LOUDSPEAKER Rackmount, IEC
This is a development of the standard diecast loudspeakers, and is designed to fill the need for an economical, robust, powered loudspeaker. Uses include talkback, line listening, cue programme, office monitoring and even small PA applications. Mains connection is IEC (CEE22) (cable not supplied), audio input is transformer balanced on XLR 3 pin female, mating connectors not supplied. Units are constructed in a virtually airtight diecast aluminium housing, to give enhanced LF performance. Front panel mains on/off and volume controls.
Two simple wall fixings are available: a 'U' bracket 76-428 permits flush wall fixing with restricted horizontal or vertical tilt adjustment, and a universal angle bracket 18-092 with horizontal adjustment also available (speaker can be mounted horizontally or vertically). Mic stand adapter enables units to mount on 3/8 inch or 5/8 inch thread microphone stands. Loudspeaker has M6 tapped insert in the top and base.
Units are also available in single or dual 19 inch rackmount
versions (3U), to provide convenient rackmount check-listen facilities.
Enclosure: Aluminium diecast
Drive unit: 10cm, full range single cone
Frequency range: 90Hz13kHz (amplifier section 40Hz20kHz)
Max. output power
(amplifier section): 10 watts at 0.2% THD, 13 watts at 3% THD
Input impedance: >20k ohms
Input sensitivity: 0dBu @ 10W output
Power: 220240V AC
Dimensions: 181(h) x 114(w) x 105(d) mm (free standing unit)
3U(h) x 105(d) mm (19 inch rackmounting)
To buy this, or if you have any queries, please contact, Mike Harris 01932 241 948, email@example.com