back to used gear

Product Ref U107

NAGRA IV.L MONO ANALOGUE REEL TO REEL 1/4" TAPE RECORDER

IV-L MONO 1/4" FULL TRACK TAPE RECORDER CCIR EQ WITH 50Hz FULL PILOT SYNC

THIS NAGRA IS IN EXCELLENT CONDITION AND PERFECT WORKING ORDER,
IT HAS BEEN SERVICED BY
``MIKE HARRIS SOUND SERVICES``AND HAS A 3 MONTH GUARANTEE

The machine has the following features:
2 x Dynamic microphone inputs, a line input on banana plugs or the 6 pin Tuchel ACC socket. It has Direct or off Tape monitoring and metering, monitoring selector with monitor speaker and level control or headphone monitoring with level control. It has 1 & 2 high pass and 1&2 LAF low frequency attenuation filters, 3 Tape speeds- 38, 19, 9.5cm/s (15-7.5-3.75ips). 50 Hz strobe roller, 1Khtz. Reference generator set a -8dB, Automatic Recording Limiter, Automatic and manual recording level, Low Frequency Attenuation, silicon rubber pinch wheel and drive belts and Ruby tape gibes. It is a full pilot recorder with pilot link plug. This recorder is supplied with the QSV x 10% or - 10% tape speed control.

It has the fixings for a 7" spool adapter and NAB spool adapter and the handle fixing screws are supplied, you can run 7" tape spools with the lid open.

I always change the XLR microphone inputs on the Nagra to 3 pin XLR sockets to suit modern microphones, this recorder also has a 3 pin XLR output plug fitted

ABOVE This Recorder comes with the Shoulder Strap fixing screw, and original Copy of Instruction Manual, a Pilot link plug, QSV tape speed control, a N-SMPS power supply, and a roll of tape with frequency run and music to test the recorder.

LEFT, A nice clean battery box, this will take 12 x U2/D or MN1300 batteries, 3 sticks of 4 x 4 amp NiCad batteries

There are some dents in the back of the recorder, and there was no battery box cover with this recorder, and the only one I have, has one of the fixing screws missing, see bottom of page.

This machine was owned by a professional Film Production Sound Mixer / Recordist,

RIGHT, There is minimal head wear on the machine The machine is biased for AGFA, Zonal, BASF 468 or 368 and the sound quality and levels between direct and off tape are identical.

ABOVE, the speed control, the STD is set flat and the LN is set 4 dB down at 10k

BEHIND THE METER, There are 2 x 200 ohm Dynamic microphone amps, these plug in microphone amplifiers are held in by one screw from underneath the recorder, if you would like to exchange one of the Dynamic for a QPM3.5 T power mic amp, It would be a free exchange

Behind them across in front of the battery box is the automatic record level circuit board, this is not always fitted.

ON THE BATTERY BOX, This Recorder is fitted with a Crystal Pilot Generator and this one is set to 50Hz, as is the UK mains frequency

The space is for the frequency meter board this display the pilot lever on the meter, this is not always fitted as the Maltese Cross indicates the pilot is working

This is a full track mono recorder with 50Hz Pilot sync, Before we had the Crystal Pilot Generators the 50Hz main frequency from the 1 volt output on the ATN power supply was used. And the Camera would be lock to the mains frequency

LEFT, battery box cover with this recorder, has one of the fixing screws missing,

QSV tape speed control

x 10% or - 10% on all tape speeds

and IV/L Instruction manual

If you would like to record on a Nagra and playback on a non pilot recorder, remove the pilot link from the pilot socket on the right hand side of the recorder, to switch off the pilot otherwise you could hear the 50 Hz pilot when you play the tape, if you are not syncing the tape to video or film camera's you can leave the pilot link unplugged.

Please note: - The switchable type mic amps are not fitted in this Nagra and the Perspex lid has some scratches. There are some dents in the back of the recorder, the battery box cover has one of the fixing screws missing, The batteries are (not included


To buy this item please telephone: Mike Harris 01932 241 948, or click the contact button for more options.