back to used gear

Product Ref B25

PC 1252, 12 VOLT 52 AMP BATTERIES IN 1300 PELI FLIGHT CASE and a new automatic LED

PC 2426, 24 VOLT 26 AMP BATTERIES IN 1300 PELI FLIGHT CASE and a new automatic LED

PC 1252, 12 VOLT 52 AMP BATTERIES IN 1300 PELI FLIGHT CASE, leads are colour coded yellow

PC 2426, 24 VOLT 26 AMP BATTERIES IN 1300 PELI FLIGHT CASE, leads are colour coded orange

New Large automatic LED is fitted, Green for full battery, flashing Yellow Green time to charge, Red you must stop using or you will shorten the life of the battery.

2 x 12 VOLT 26 AMP BATTERIES IN PELI CASE WITH 1 X 4-PIN XLR OUTPUT, 1 X FUSE & 1 X L.E.D

*** PLEASE ADD £25 FOR EACH EXTRA OUTPUT, *** ADD £15 FOR POS(+) & NEG(-) FUSES *** ADD £20 IF YOU WOULD LIKE THE BATTERY TO SWITCH ON WHEN YOU PLUG IN THE OUTPUT LEAD, THIS WOULD USE PIN 3 OF THE 4 PIN XLR

The Peli Cases comes in black, sand, green, silver, yellow or orange

24 VOLTS battery box output with 4 pin XLR connectors is on PIN 1 NEG (-), PIN 2 POS (+)

12 VOLTS battery box output with 4 pin XLR connectors is on PIN 1 NEG (-), PIN 4 POS (+)

24 VOLTS battery box output can be fitted with a 2 pin SPEAKON connectors PIN - 1 NEG (-), PIN + 1 POS (+) a 2 pin Speakon is preferred because you cannot plug 4 pin Speakon plug into it. The 4 pin is fitted to the 12 volt battery box

12 VOLTS battery box output is on a 4 pin SPEAKON connectors is on PIN -1 NEG (-), PIN + 1 POS (+)

The 4 pin NC4FX is a 9 amp connector so the box max fuse is 9 amp, if you would like a 20 amp output I can fit the SPEAKON connector

The Peli Case Battery is 270 x 246 x 174 mm and is 13.82 Kg

OUTPUT LEADS a 4 pin XLR is used to avoid accidental connection to audio inputs or microphones

Neutrik 4 pin XLR to 4 pin XLR 10 amp output leads £25

Neutrik 4 pin XLR to 2 X 4 pin XLR 10 amp output Y leads £35

Neutrik 4 pin XLR to 2 X 4 pin Hi-Rose 5 amp output Y leads £60

Above leads with 1 x NC4MRX 4-pin XLR Right Angle plug add £3.50

4 pin to clips for charging your car battery £20

It is recommended that a stabilized constant voltage charger be used with current limiting to restrict the current flow to the permitted maximum. See Ref C2 C3 & C10. for suitable chargers, Car battery type chargers must never be used. These batteries should never be left in a severely discharged condition or get hot when charging.

Charge every 6 months when not in use

The sealed lead acid batteries have proved to be a reliable and economic alternative to nickel cadmium, nickel metal hydride which need to be discharged before recharging if part used and have expensive charging systems plus the memory problems, or expensive Lithium batteries.

The sealed lead acid batteries with the correct charger has no such problems. If the battery is part used it will take less time to charge and for best results, when the battery is fully charged and ready for use, it can be left on float charge until required. So if you forget to take it off charge at the weekend no problem it will just improve the performance by balancing the cells.

Click on this box for TRANSPORTATION DOCUMENTS click to find out more


To buy this item please telephone: Mike Harris 01932 241 948, or click the contact button for more options.